American holly: One of the whitest woods known

American holly: One of the whitest woods known

American holly (Ilex opaca), the state tree of Delaware, is a fantastic tree, with brilliant red berries and dark green leaves that are popular decorations during the Christmas season. 

The tree has leaves, so it is a hardwood, but the leaves stay on for three years, which make it an evergreen.
The red holly berries are mildly toxic to people when ingested and the sap is also harmful to humans. However, many species of birds love the berries.

Holly trees are scattered from the maritime forests of Massachusetts along the coast to Delaware. It grows inland into several Pennsylvania counties and then abundantly southward throughout the coastal plain, Piedmont, and Appalachians. The range extends south to mid-peninsular Florida, west to eastern Texas and southeastern Missouri. 

The tree is often 60 feet tall and up to three feet in diameter, although the larger trees have been found. Heavy foliage harvesting for decorations mean it is hard to find large trees; in other words, wood supplies are limited and prices are high for good holly lumber.

The attraction of holly, in addition to the foliage and berries, is that holly is one of the whitest woods known. In the past holly veneer and veneer inlays were very popular. Certainly, the use for specialty items, such as engravings, scroll work, and carvings has been very important. Whip handles was one old use, as well as for keys, pegs and other items in musical instruments. One surprising use is that sometimes this beautiful white wood was stained black and used as a substitute for ebony, even though holly is not as hard.

Processing suggestions and characteristics
Density
. The density is approximately 38 pounds per cubic foot, typical for many hardwood species. Kiln-dried lumber will weigh about 3 pounds per board foot.

Drying. Drying is tricky. The wood is subject to discoloration if dried too slowly. For best results, use only winter-harvested logs. The wood needs to be put into a kiln at a low humidity within hours after sawing; hence, most drying is done at the sawmill site. Dry promptly using a white hard maple schedule. Use 12-inch sticker spacing and weights on pile tops. Shrinkage of flatsawn lumber during drying is nearly 8 percent.

Gluing and Machining. Gluing is fairly easy for a hardwood species. Machining is high quality. When sanding with fine grit paper, the wood develops a high luster or polish.

Stability. Holly is reasonably stable when the moisture changes, but irregular grain can result in some warping occasionally.

Strength. The strength (MOR) of holly is 10,300 psi. The stiffness (MOE) is 1.1 million psi. Hardness is 1,020 pounds.

Color and Grain. The sapwood is much whiter than the heartwood, but both are very white. Actually, sapwood is quite wide in the tree, so often the lumber is 100 percent sapwood. The wood can be buffed to provide a high polish. The grain is very fine. There is no figure in the grain, so irregular grain is not easily detected in the finished product. When purchasing holly wood, be sure to clearly state the color that you require and what the process will be for returning wood that is off-color.
 

This post appeared first on http://www.woodworkingnetwork.com

Leave a Reply

Your email address will not be published.

This website nor its owners are an actual service provider, this website is a referral service. When you place a phone call from this website, it will route you to a licensed, professional service provider that serves your area. For more information refer to our terms of service.

© WoodFloorRefinishing.info

(877) 959-3534